Rated to IP67 and IP69, capable of submersion and high pressure water blasts, with a dust proof Housing manufactured from heavy duty diecast alloy designed to withstand hours of corrugationsĪnd extreme conditions – featuring a shockproof polycarbonate lens amnd stainless steel mounting Distanceĭesigned and engineered to produce the the closest imitation light to natural daylight (6000K),Įnsuring the area you’re lighting is well lit. Three (3) light settings, highīeam spot, low beam flood or combination. Functionalityĭual function, 20W high beam LED spotlight and low beam floodlight. Housing manufactured from heavy duty diecast alloy with a shockproof polycarbonate lens. Rated to IP67 and IP69, capable of sumersion and high pressure water blasts with complete protection from dust. Repeat for all other actuators.Dual function, 20W high beam LED spotlight and low beam floodlight.Ħ000K white light to imitate natural daylight and features 2 x 10W high lux output Cree-XPL LED’s. Drill one hole at each end of the bracket with a 4.5mm drill, then screw the bracket onto the window frame using the 8g x 12 screws supplied making sure that the bracket does not interfere with the movement of the handle. Hold a protection bracket over the top of an actuator and mark the position for holes to be drilled through the bracket. If the pins are not traveling in the same direction then reverse the connections to each actuator that is travelling in the opposite direction. Operate remote controller and make sure all actuator pins travel in the same direction at the same time and when the lock button is pressed all the pins are in the locked position.Connect all actuators to cabling using female bullet connectors and then connect power to controller. Make sure the duct does not interfere with the movement of the pin of the actuators, however loom tube could be used instead of the plastic duct. We found it easiest to run cables in loom tube to inside the canopy and then run a piece of 25 x 16 plastic electrical duct under the window frame from front to rear on each side of the canopy holding it in place with double sided tape and some dobs of silicone. Referring to the wiring diagram, run a 15amp cable to the controller from a positive power source and connect the black wire to a negative, then run 2 wires (3mm 10amp) from the controller white & white/black to the first actuator and then loop wires to all other actuators. Mount controller anywhere in cabin (this is important for ease of accessibility in the event of unforeseen failure).Repeat step 1 & 2 for all 6 window handles.The bracket can also be bent up or down to ensure the actuator pin engages with the pin when locked and clears the bracket when unlocked. This can be done by using a file to make the hole larger. Note: The hole in the bracket may have to be enlarged to ensure that the pin moves freely with the window handle in the open or closed position.Secure actuator to window frame using the 2 of the 8g x 12 screws. Now push the pin of the actuator fully down to make sure that the top of the pin clears the bracket so the window can be opened. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |